TB6612FNG Dual DC Stepper Motor Drive Module Controller Board Replace L298N for Arduino

Item Description
The TB6612FNG motor driver can control up to two DC motors at a constant current of 1.2A (3.2A peak). Two input signals (IN1 and IN2) can be used to control the motor in one of four function modes - CW, CCW, short-brake, and stop. The two motor outputs (A and B) can be separately controlled, the speed of each motor is controlled via a PWM input signal with a frequency up to 100kHz. The STBY pin should be pulled high to take the motor out of standby modeU.Logic supply voltage (VCC) can be in the range of 2.7-5.5VDC, while the motor supply (VM) is limited to a maximum voltage of 15VDC. The output current is rated up to 1.2A per channel (or up to 3.2A for a short, single pulse).Board comes with all components installed as shown. Decoupling capacitors are included on both supply lines. All pins of the TB6612FNG are broken out to two 0.1" pitch headers; the pins are arranged such that input pins are on one side and output pins are on the other.

Features:
Recommended motor voltage (VMOT): 4.5 V to 13.5 V (can operate down to 2.5 V with derated performance) Logic voltage (VCC): 2.7 V to 5.5 V Output current maximum: 3 A per channel Output current continuous: 1 A per channel (can be paralleled to deliver 2 A continuous) Maximum PWM frequency: 100 kHz Built-in thermal shutdown circuit Filtering capacitors on both supply lines Reverse-power protection on the motor supply Schematic diagram Arduino testing connection:

Schematic

Download:
downloadable pdf

Package Include:
1pcs TB6612FNG Motor Drive Module Replace L298N for Arduino