Features: In short, 204-pin small outline dual inline memory modules (SODIMMs) are the form factor used to provide DDR3 memory modules for notebook computers and other small form factor computing platforms. 204-pin SODIMMs are currently available in PC3-8500 (DDR3 1066MHz) and PC3-10600 (DDR3 1333MHz) speeds.
To use DDR3 memory, your system must have both a 204-pin SODIMM slot and a chipset that supports DDR3 memory. A DDR3 SODIMM will not fit into DDR2 or DDR memory sockets. (Information about which memory technology your system uses is included in the Crucial Memory Advisor tool.)
SODIMMs are smaller and thinner than regular DIMMs, and the 204-pin SODIMM PCBs are always ~2.6 inches long and are usually around 1.18 inches high (though the heights can vary slightly). The...
Features: CT2KIT204864BF160B is a 32GB kit consisting of (2) 16GB DDR3L 1.35V Notebook module that operates at speeds up to 1600 MT/s and has a CL11 latency. It is dual voltage and can operate at 1.35V and 1.5V. It is Unbuffered and is non-ECC. It conforms to the industry standard SODIMM layout of 204 pins and is compatible with computers that take DDR3L SODIMM memory.
Features: CT204864BF160B is a single 16GB DDR3L 1.35V Notebook module that operates at speeds up to 1600 MT/s and has a CL11 latency. It is dual voltage and can operate at 1.35V or 1.5V. It is Unbuffered and is non-ECC. It conforms to the industry standard SODIMM layout of 204 pins and is compatible with computers that take DDR3L SODIMM memory.
Features: JEDEC standard 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V) Power SupplyVDDQ = 1.35V (1.28V ~ 1.45V) and 1.5V (1.425V ~ 1.575V)800 MHz fCK for 1600 Mb/sec/pin8 independent internal banksProgrammable CAS Latency: 11, 10, 9, 8, 7, 6Programmable Additive Latency: 0, CL-2, or CL-1 clock8-bit pre-fetchBurst Length: 8 (Interleave without any limit, sequential with starting address "000" only), 4 with tCCD = 4 which does not allow seamless read or write [either on the fly using A12 or MRS]Bi-directional Differential Data StrobeInternal(self) calibration: Internal self calibration through ZQ pin (RZQ: 240 ohm +/- 1%)On Die Termination using ODT pinAsynchronous ResetPCB: Height 1.18" (30mm), double sided component MEM_Recommend Use:
We‘re shipping as usual! The Canada Post strike only affects certain remote deliveries and PO Boxes. Details
Holiday Shipping Details & Extended Holiday Returns
