Important 1.
ARGB music controller: 10pcs 6pin fan interface, 2pcs 4pin light strip interface. Connect D-type 4pin power connector to use. Support 5V 3pin Sync cable (if there is no 5V 3pin interface, you can control it by remote control) 2. The Music Controller supports Motherboard synchronization Aura Sync and comes with Music Function. But the motherboard must have a 5V-3PIN interface.
Must understand before installation: Follow the instructions in the picture to connect, the wrong interface will cause the controller to burn out. The big 4PIN interface of the power supply and the big 4PIN interface of the controller are connected separately, turn off the power before connecting, and turn it on after connecting. Do not connect equipment other than the controller. The RGB fan has two voltages, 12V for the fan and 5V for the lamp. To prevent the lamp bead from burning out by mistake, be sure to plug in the power when the computer is off. Do not operate with electricity. Note that the red jack on the control box is the power input. It cannot be plugged in the wrong position. Inserting the wrong position will cause the lamp beads to burn out. After inserting, check whether the control box is correct and then power on!