UV light meter for Ultraviolet radiation intensity and energy dose measurement for UV-C germicidal lamp and UVC LED

I. LS125 UV Light Meter HostLS125 is a smart host that can support different probes. The host equipped with the probe can be used for ultraviolet intensity and energy (dose) detection. When using the host, you need to buy the corresponding probe to use with it according to the test needs.

II. LS125 UV Light Meter Parameters

III. LS125 UV Light Meter Probe SelectionThe probe must be purchased separately.

The selection table is as follows:

IV. Probe Parameters

1. UVC-X0 probe

2. UVCWP-X0 probe

3. UVCLED-X0 probe

V. Features1. Three measurement units can be switched, namelyµW/cm², mW / cm², W / m². Data conversion between different units does not require manual calculation.

2. With rich statistical functions, real-time power value, maximum value, minimum value, average value, measurement time and energy value are displayed at the same time.

VI. Calibration Certificate1. Provide factory calibration report

2. The UVC-X0 probe is mainly for R&D and design of 254nm germicidal lamps. We can provide a calibration certificate (which has been approved by CNAS and ilac-MRA), but the testing fee needs to be paid separately, and you need to wait for a longer testing time. For details, please consult Customer service

3.There are no testing standards for UVC LED, so we cannot provide any traceable reports for UVCLED -X0 probe. The data of UVCLED-X0 is calibrated based on the manufacturer's standards of .

VII. How to use it? Take the UVCLED-X0 probe as an example to explain the operation steps