PCIe SATA controller card 10 ports with 10 SATA cables and slim bracket - 6Gbps SATA 3.0 PCIe card supporting 10 ports of SATA 3.0 devices

Descriptions:
Supports communication speeds of 6.0 Gbps, 3.0 Gbps and 1.5 Gbps.
Support for native command queue (NCQ).
Support hot swap and hot swap.
Compatible with SATA6G, 3G and 1.5G hard drives.
Bus interface: PCI-Express x4 slot
Expansion interface: 10 ports SATA3.0 interfaces
System requirements: There is an available PCI Express X4 slot, which also supports PCI-E X8 X16

Note:

-only recognize 4 disks, please know!
-The SATA3.0 PCI-E card must be installed in the PCI-E slot of the motherboard and can not be inserted into the PCI slot.
-The fastest speed for PCI-E 2.0 is 380-450 m / s. When connected to PCI-E1.0, the speed is only 200-300 m / s. Different computer configurations and SATA SSD have different speeds.
-If all ports are used at the same time, the speed slows down.
-We recommend using this SATA 3.0 card in the PCIE2.0 or 3.0 slot for the fastest speed.
 

-ATA port multiplier is not supported if the driver is not installed.We need to install the driver to recognize all disks.
-Make sure the computer is turned off before inserting or removing the card. Then insert the card to avoid damaging the motherboard or expansion card.
-This 10-port SATA card can be installed without a driver. If it is unstable or has other obstacles, you can send a message to the seller to send the driver for you.
-If the light is on and the disk cannot be released, it is generally because the load of the power cord is too heavy. A power cord can carry up to 3 disks.

Package Contents:
1 * 10 Port SATA 3.0 expansion card
1 * Low bracket
10 * SATA cable

Please feel free to send a message to the seller if you have any questions about the product.