Mayhems Blitz Kit | Part 1 & 2 (MBK)

Mayhems Blitz Pro Cleaning System is the most comprehensive cleaning kit ever released for liquid cooling computers. It has been developed to clean you radiator’s better than new and leave your system in perfect condition. It even comes with a electronic pH test meter so you can check your levels and keep up with regular maintenance on your systemEven though this is a cleaning solution it is not a long term effective inhibitor. Never leave it in your system longer than 24 hours. This cleaning system is not safe to use around children and animals.

Part 1 and Part 2 of the system uses highly effective cleaning acids down to PH 2 and you must take appropriate measures when using such products. You can dispose of the fluids down the drain once they have been diluted.
Contents: · 100ml Mayhems Blitz Part 1, 100ml (will dilute to 2 Ltrs of fluid) · 100ml Mayhems Blitz Part 2, 100ml (will dilute to 4 Ltrs of fluid) · Rubber Gloves 4 sets· Safety Goggles· Instructions· Warning SheetPart 1 Mayhems Blitz Pro Cleaning DO NOT USE ON ALUMINIUM RADIATORS For internal use on Capper / Brass radiators only. Do not use on plated products. Do not spill on paint work and if you do so, rinse off immediately. · Maximum effectiveness· Rapid neutralisation of surface rust, contamination and oxidation· Rigorous removal of mineral scale deposits· Excellent suspension of particulates· Low foaming· Hard water tolerant· Can be disposed of down grey-water (waste / outside) drain· With "Care" this is easy to handle and straight forward to use· May Improve heat transfer rateUsage of Part 1 of the Mayhems Blitz Pro Cleaning System 1. Put on the Gloves provided in the kit. 2. Mix Part one with deionised water /distilled water (either will do) to a ratio of 50ml of part 1 to 950ml of water. 3. Add to the radiator and clean up any spills immediately. 4. Vent the system of any trapped air and cap the radiator. 5.

Leave in Radiator between 6 to 12 hours. 6. After empty down the waste drain. Refill with deionised water /distilled water (either will do) and rise out. 7. Repeat step 6 two times. 8. Refit to loop and move to Part 2 of the cleaning system. Part 2 Mayhems Blitz Pro Cleaning System · pH neutral (Ph7 - 0.5 / + 0.5 )· Effective neutralisation of contaminants. · Good removal of slime, silt & detritus· Excellent suspension of particulates· Hard water tolerant· Can be disposed of down grey-water (waste / outside) drain· May Improve heat transfer rateUsage of Part 2 Mayhems Blitz Pro Cleaning System1. Drain existing system contents. 2. Mix Part two with deionised water / distilled water (either will do) to a ratio of 25ml of Mayhems Blitz part 2 to 975ml of water. 3. Mayhems Blitz Part 2 will create a lot of foam. Please add to system slowly, do not over fill. 4. Vent the system of any trapped air. Do this by tilting the pc to release any tapped air from the radiator. 5. Check for leaks.

Using just the pump, recirculate the fluids for 24 hours continuously. Regularly check any installed filters and clean as necessary. 6. Refill with deionised water / distilled water (either will do). 7. Run for 30 minutes8. Empty out and refill with deionised water / distilled water (either will do) 9. Run for 30 minutes10. Empty out and fill with your favourite coolant. WARNING This cleaning system is not safe to use around children and animals. Part 1 and Part 2 of the system uses highly effective cleaning acids down to PH 2 and you must take appropriate measures when using such products. You can dispose of the fluids down the drain once they have been diluted.