QY6-0059 QY6-0059-000 Printhead for iP4200 MP500 MP530 New Replacement

Description:
Other Features:
stable characteristics, high reliability, according to factory specifications. Easy and simple installation
Applicable model: for C-anon IP4200 MP500 MP530 QY6-0059 Printers
Use scene: printer nozzle
Printer for Head only, other accessories in the picture is not included!

Specifications

:
Item Type: Printer for Head
Material: ABS
Color: As shown
Model: QY6-0059
Size: (approx) 11x10x 4.5 cm
Printing color: Full Color
Quantity: 1 Pc
Precautions:
The for head surface of the nozzle is very fragile and must not be bumped. It must be protected. Its surface layer is an aluminum sheet, and the inner layer is coated with a crystal oscillator and a very small tube. It will be concave and deformed when touched. Even if it breaks, the nozzle will be scrapped;
2. Before installation, please make sure that the other parts of the printer are normal, especially the motherboard to ensure that they are normal, otherwise the new print for head may be burned out.

3. When connecting the plug and cable, do not bring, and make sure that it is in good contact with the socket and does not for touch the feet, otherwise, it will cause the nozzle to be short-circuited and burned;

4. The steel shaft should also be clean and smooth. You can wipe it with a paper towel with some lubricating oil. Do not directly add oil to the shaft. The excess oil will flow to the nozzle and cause damage;

5. After the machinery and circuit are all correct, check the water circuit. First, check that the amount of water in the cartridge is insufficient; second, check whether the small cleaning and the suction pump are dirty;

6. There may be air in the newly installed print for head, so it will not print normally immediately. Only when the air in the for head is completely exhausted can the line be normal; first, intermittent cleaning can be used (only two cleanings at a for time, then stop 30 Wash 2 times after 2 minutes) Repeatedly over-cleaning will cause accumulation in the cleaning pump, which will not only cause color mixing and leakage, but also waste; secondly, you can print more pictures to let the nozzle discharge air during work; Again, if the machine has led out the waste tube, you can cut off the power first, and then use a rubber tube to draw out the waste tube until 3-5ml of is drawn out, then turn it on and clean it once with the machine normally. It is equivalent to artificially extracting the air from the for head, and the is that it is easy to cause the cleaning pump to pile up.

7. Please let professionals install or operate, damage caused by human causes, NO refund.
Note:
: 1cm=10mm= 0.39 inch
Please allow 0-3cm error due to manual measurement. pls make sure you do not mind before you bid.
Due to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!
Package Includes:
1 x Printer for Head