PCI E Express 1X to 3 Port 1X Switch Multiplier HUB Riser Card +USB Cable

PCI E Express 1X to 3 Port 1X Switch Multiplier HUB Riser Card +USB Cable

Type: M.2 SSD To Interface Type: PCI Express100% brand new and high qualityIf you need more than one x1 slot on the motherboard was not any so much, it you can think about it. It consists of two parts, one main card, interface installed via X1 on the motherboard, two equipment cards, both of which are connected together via USB 3.0 cable.The device card also uses for the United States Pericom Pericom PI7C9X bridge chip, for switching , between.But even USB 3.0, but also the theoretical bandwidth 5Gbps (625MB / s), one Into four Then remove the loss would only 150MB / s, and even 1.x single-channel bandwidth also has 250MB / s, So this stuff more than enough to give you the best slots, there will not be enough bandwidth, not only for the performance requirements of the place. Therefore, the transferred slot is the best version above 2.0, the 3.0 version is better.Several Divided 1X slot all is gen2 mode, even if gen1 previously ,it can be okPlease Note: This product does not apply to GTX1050 and higher version ie cards.color: bluematerial: plasticPackage Contents:1 * Riser card1 * Motherboard side4 sets * Copper post screws1 * cableOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.